Tricolor TV receiver and TV: how to connect and configure

creativecommons.org

How to connect the Tricolor TV receiver to a TV

Due to the variety of video and audio connections and different interfaces, users cannot always independently figure out how to connect the Tricolor set-top box to their TV. Let's figure out what needs to be done to properly connect the receiver on your own.

How to connect an old TV to a Tricolor receiver

Of the entire set of equipment from Tricolor, the most expensive element is the receiver. Therefore, before purchasing such a set-top box, be sure to go to the operator’s official website and check the list of equipment recommended for use in order to avoid inconsistencies and cases where the equipment turns out to be incompatible.

Tricolor TV receiver and TV: how to connect and configure

In addition to the connector for the power cable, which is used to connect to the electrical network, the rear panel of the receiver also has the following outputs:

• Analog (RF).
• AV (audio-video) output.
• Video output S-Video.
• SCART connector.
• HDMI connector.

creativecommons.org

How to connect the Tricolor TV receiver to a TV: description, instructions

The AV connector is still the most common type of connection, although it is gradually being replaced by more modern options like HDMI. But so far there is an AV connector on almost every TV set and receivers from satellite operators, including Tricolor.

The S-Video connector is used on more modern devices to transmit video signals. Outwardly, it resembles the port used in system units to connect a mouse and keyboard.

SCART is a standard common in Europe, allowing simultaneous transmission of audio and video signals through one connector. At the same time, the quality of video transmission is comparable to that obtained when using the S-Video connector. The cable is quite thick, with a rectangular connector and 21 pins inside. To connect such a cable, simply connect it to the corresponding connectors on the satellite receiver and TV.

To transmit video signals in the highest quality, up to 1080i, a Y Pb Pr component cable is used. At the end of the cord is a set of cables that transmit signals according to their colors: green, red and blue for video signals, and red and white for audio signals.

To connect the TV and receiver yourself using a component cable, it is enough to connect the cables with the necessary connectors on both sides in accordance with the instructions, without mixing anything up.

HDMI is a modern format for transmitting video and audio signals. The main advantage is the absence of additional decoding during signal transmission. The video gets to the TV without loss of quality when moving from the receiver.

If this type of connection is supported by the TV and receiver, then it is best to use this option.It allows you to transmit images in high HD quality.

Is it possible to connect an old TV to a Tricolor receiver and how to do it: recommendations

Older TVs, depending on the model, can be connected either using an analog RF connector, which is now considered obsolete and no longer used in new models, or using an AV connector, which is found in almost any television receiver.