Soundproofing heating pipes in an apartment: how to do it, list of materials

Soundproofing of heating pipes is usually done using a special membrane with a layer of felt, which dampens extraneous sounds well. However, if this is clearly not enough, a box is built around the riser, inside which material is placed, for example, mineral wool. Basic methods of noise protection and step-by-step installation instructions can be found in the presented article.

Sound insulation materials

The sound insulation of heating pipes in an apartment depends on the material chosen. The following are usually used:

1. Special foam rubber is easy to install, absorbs noise well, open installation is available. But you need to take into account that when heated for a long time, it is destroyed, so it is not particularly durable.
2. Shumoplast - granules on an elastic base with a rubber additive and an acrylic binder. Sound insulation of heating radiators in an apartment is especially effective due to the high porosity of the granules. Moreover, they do not absorb moisture, so waterproofing can be abandoned. It shrinks slightly within 5%, is very durable, and does not lose its properties even over the years. Easy to install, but requires at least 24 hours to dry completely.
3. Heating risers are also soundproofed with acoustic decorative slabs. These are panels with internal perforation; the outside is covered with veneer of different colors. The material is environmentally friendly and does not emit harmful substances even during combustion.It is easy to install and quite effective, but is significantly more expensive than many other varieties.
4. Sound insulation of heating pipes in an apartment is also done with traditional materials, for example, mineral wool. This is a natural raw material that is completely safe and inexpensive. But you need to take into account that it retains heat, and if the heating is weak, it is better not to risk it. In addition, cotton wool is not resistant to moisture and requires mandatory waterproofing.
5. Soundproofing of heating risers can also be done in a simple way - by gluing a membrane. It is fixed directly to the surface, and the joints are sealed with special foil-coated tape.

How to make soundproofing: step-by-step instructions

As a rule, a heating riser does not cause much inconvenience compared to the same sewerage or water supply pipes. Therefore, in most cases, sound insulation of heating pipes comes down to gluing them with a special membrane.

The step-by-step instructions look like this:

1. Degreasing the riser and all jumpers using white spirit or acetone, wiping with a clean rag.
2. Measuring circumference (pipe circumference).
3. Take a pencil and mark it on a sheet of soundproofing material and cut it with a knife.
4. Take a building level and draw a straight line along the riser (from top to bottom).
5. Glue the membrane, preferably with an overlap of 3-4 cm. If it has a layer of felt, trim it slightly along the edges with a sharp blade.
6. When they reach the bracket, a corresponding slot is made in the membrane.
7. All joints are treated with foil-coated tape.

If the problem is acute, then sound insulation of the heating riser in the apartment should be more effective.Therefore, a box is first constructed, for example, from plasterboard, and the internal surfaces are laid out with mineral wool, polyethylene foam or other materials. They also build a box for heating radiators, having previously made a grille at the point where the hot air exits (at the top of the radiator). However, this method can only be used if there is too much noise and a sufficiently efficient heating system - otherwise it will be noticeably colder in winter.