Laying parquet boards using the floating method
Before you finally make a decision on the method of laying this or that material, you need to understand the advantages and disadvantages. In this article, in addition, we will consider what difficulties may arise in the process.
The content of the article
Floating laying of parquet boards: features
Unlike other options, the presented one assumes the absence of various fastenings - only a locking connection. As a result, you can notice the formation of a floor covering in which the base and walls are not tightly connected.
REFERENCE. A gap of a certain size is provided between the elements - 1 centimeter.
Advantages of the method
The huge demand for the presented method is explained by the following advantages:
Regardless of how many years the structure will be in operation, the connection does not weaken. Consequently, durability and reliability are guaranteed to every user.- The raw materials themselves are natural and therefore environmentally friendly.
- As for the installation itself, the process occurs without difficulty and does not require much time.
- The temperature to which the product is exposed will not affect the strength.
- To perform the procedure you do not need to have special knowledge and skills.
- When it comes to appearance, it is about providing a cohesive whole.
Thus, everyone is capable and able to use this type of material. Moreover, the resource itself has all the important characteristics.
Difficulties that may arise when laying parquet boards using a floating method
Of course, the master is recommended to first study those points that may interfere with the process. Respectively:
- If you plan to reproduce the installation at the site of the heating riser or near the doorway, then you will have to cut the structure in the necessary places so that the load is distributed evenly in the future.
ATTENTION. You need to trim with a margin - the area should be a few millimeters larger.
- When cutting, you will need to use glue, since fixing the die is quite important. Before this, the joints in the cut areas should be processed.
