Is it possible to disassemble laminate and put it back together?

Sometimes it happens that during repairs it is possible to avoid the complete dismantling of individual structures. Is it possible to disassemble laminate flooring and put it back together? The material can also be dismantled, but not every type.

Is it allowed to disassemble laminate flooring and put it back together?

First you need to determine whether it is worth disassembling the coating at all. If it is necessary to repair a minor defect, you do not need to carry out complete dismantling. However, if you decide to disassemble the laminate, make sure that the adhesive joining method was not used to connect the boards - such material cannot be disassembled without damage.

If the type of joint does not involve the use of glue, and the boards are connected with a lock, the covering can be dismantled for repair or subsequent installation in another place.

ATTENTION! If you used glue during installation, you will not be able to re-lay it without damage. In this case, it is better not to start dismantling work.

What are the dangers of reusing laminate flooring?

Is it possible to reinstall laminate flooring a second time? Good material can withstand several installation cycles, but over time its condition still deteriorates. A higher-class product can be repositioned more times without fear of damaging it.

To make sure that the laminate will not deteriorate after repeated relaying, you need to know its strength level. Experienced experts recommend choosing a coating of strength class 32 and higher.

How to reinstall laminate flooring if it was installed incorrectly

Can laminate flooring be reused? Of course you can. After making sure that no glue is used to join the boards, you should arm yourself with tools. Should be used:

• Hammer to knock out hard-to-remove boards;
• Bracket for working in hard-to-reach areas;
• A screwdriver for removing skirting boards if it is necessary to completely dismantle the covering;
• A chisel for lifting dies.

Dismantling begins from the far wall of the room and ends at the entrance. Usually, if the coating is damaged, one or two dies need to be replaced, however, if you need to completely remove the material, you must first remove the baseboards, and then begin dismantling the coating itself. You should pry the first die and carefully lift it with a chisel. The boards should come apart. For complete dismantling, repeat the operation until the work is completed.

Replacing several boards will cost much less than replacing it completely, so the issue of re-flooring is quite relevant.