How to remove drawers from a chest of drawers on runners
There is always some possibility when using a particular device that it will fail. Boxes are also not considered an exception, and this is a completely normal phenomenon. It often happens that small objects roll inside them, or closing does not occur completely.
In any case, it is recommended to completely remove the structure. However, not everyone can do this, so this article will describe instructions for all actions in this situation.
The content of the article
How to properly remove drawers from a chest of drawers on runners
The whole process consists of the following simple steps:
- First you need to pull out the drawer itself to the maximum distance it allows. There are plastic fasteners on the sides, you can immediately notice them. It should be remembered that since there are 2 guides, therefore, there are also 2 fasteners (one on each side);
- Next, you should lower the small “antennae” mechanism down, and then gently pull it towards you. He must come out. There are 2 types of design. If in your case there is a symmetrical arrangement, then both parts should be omitted. There is also a mirror placement. Then it is important to lower one of the “antennae” and pull the other up;
- The resulting external particles must be lowered down.They will be located on both the right and left sides. After the described manipulations, the unit should be pulled out of the guides smoothly and without difficulty;
- And after removal, you can carry out the task for which you performed all the actions performed;
- To put the device in its original place, you should perform the entire presented algorithm, only in reverse order. Namely: equip the runners and push the box until it clicks into place.
REFERENCE! It is better to insert the box straight to avoid blocking the bar, which most often contributes to the creation of obstacles when retracting the entire structure.
Why is the system convenient to use?
Due to their list of advantages, these models are in greatest demand among potential users.
- When compared, for example, with roller mechanisms, telescopic fittings have a long service life.
- This is due to the fact that the design is resistant to stressful situations and high quality production.
- It is also capable of withstanding the heaviest loads.
- As can already be understood based on the instructions, the structure is easy to use.
- In addition, such guides cannot be installed incorrectly.
- They can be placed at a variety of heights.
Expert Tips for Removing Drawers from Dressers
If you have difficulty performing all of the above steps at the beginning of the article, try carefully lifting the box itself to make the steps easier when performing them. Sometimes resistance may appear. It is then that it is advisable to extend the mechanism all the way and try to place it again in its original position.
REFERENCE! It may also happen that you have to unbend the fastener along with the elastic band, but you should understand that it will eventually fly off. To obtain slip, you can resort to special solutions that are designed specifically for this. The main thing is that their number should not be large.