How to use a circular saw? Rules for using the tool

Using an electric saw, you can perform various actions, including trimming and trimming boards, and cutting sheet materials. The tool is powerful enough to work not only with timber or wooden boards, but also with parts made of plastic and organic glass. Instructions on how to use a circular saw and how to properly set up the device are described in the article.

What actions are performed with a saw?

If you describe what you can do with a circular saw, you'll get a pretty big list. This is trimming workpieces (including those that cannot be worked with with a pendulum saw), trimming them for floor installation, and trimming various parts, including at an angle.

The tool also allows you to perform other operations:

• cutting workpieces lengthwise at different angles;
• sampling of quarters in timber elements, boards;
• cutting the sheet (a guide is used for this);
• cutting organic glass, plastic parts;
• using the saw as a stationary tool (for this it is pre-mounted to the table).

Step-by-step setup instructions

To understand how to use a circular saw, you need to set up the tool and then get to work. The algorithm of actions is as follows:

1. The device must be placed on the end side.
2. Lock the spindle by pressing the button.
3. Release the clamping screw and outer flange.
4. Turn the housing clockwise and install the disc.
5. Reinstall the flange and clamping screw.
6. Tighten securely with a wrench.

How to use the tool

After this, you need to figure out how to work with a circular saw. First of all, you should make sure that there is nothing under the part; it should lie on a flat surface. The main sequence of actions is as follows:

1. Mark with a pencil the straight line along which the cutting disc will go.
2. Set the parameter for the depth at which the cut will be made. The edges of the disc should only protrude slightly below the edge of the part. For example, its thickness is 30 mm, then the depth should not exceed 40 mm.
3. Please note that the leading edge of the cutting disc must be positioned exactly according to the mark.
4. Start cutting, looking strictly straight at the guide on the right (not at an angle, so as not to distort the perception).
5. To understand how to cut correctly with an electric saw, you need to constantly monitor the guide. In this case, the base should be held flat on the workpiece.
6. The tool is pushed with sufficient force. This is necessary so that the move is confident, but at the same time without unnecessary pressure.
7. Upon completion of cutting, you need to make sure that the casing has returned to its original position (for safety reasons).

Figuring out how to use a hand-held circular saw is easy. In this case, the tool must be properly prepared for work. When making a cut, apply sufficient force so that the disc moves in a straight line.