How to extend the life of a chainsaw
In order for a chainsaw to remain a quality tool with good performance, it is necessary to properly maintain it care. This will extend the life of the unit. Otherwise, it may quickly fail and additional repairs will be required.
The content of the article
Chainsaw maintenance: how to extend its service life
If a beginner has purchased a chainsaw, then he will have to learn how to properly fill in fuel, without which the equipment will not be able to operate. Gasoline allows the engine to function, but oil is needed to chain was always blurry. The future fuel is made up of these components. The device will not work on gasoline alone. The ratio of components is 50 to 1. Gasoline is available in larger quantities, its minimum grade is 92.
Fuel must be poured into strictly designated compartments. They are marked on the body. The sign in the form of a gas pump indicates that this is a container for gasoline. The oil is poured into the compartment with the image of a drop.
It is recommended to use specialized oil from the manufacturer. The component should not be allowed to drop to the minimum in the container.
There is a bearing on the outer edge of the tire. It is necessary to lubricate it. It is convenient to use a syringe for this. A few drops of oil are enough. This procedure should be carried out regularly, once a month.
All specified actions for filling and lubricating parts are carried out only on a horizontal, flat surface.
After each use of the tool, it is recommended to thoroughly clean it of dirt. This will prevent it from breaking in the future. You must remember your own safety when performing any manipulations with a chainsaw.
When purchasing a new chain, it must be immersed in oil for 12 hours. This will allow each element to be thoroughly saturated with the composition. Then the chain will be completely ready for use. When installing it, several points should be observed:
- The product must fit tightly to the headset. Sagging from below is not allowed.
- The chain should move by hand along the bar.
After installing the part, the device starts at medium speed and runs idle for several minutes. Then the equipment is turned off and the chain tension is checked.
Do not tension the chain while it is warm. The procedure is started only after it has completely cooled down.
It is necessary to carefully monitor the condition of the drive sprocket and prevent serious wear. The part is replaced when wear is 0.5 mm.
During operation, burrs form on the tire. We need to get rid of them. It is enough to arm yourself with a file. This will reduce tire wear.
Why does a chainsaw need maintenance?
The chainsaw is subject to heavy loads during operation. The situation is not always complicated by the proper conditions in which it is operated. Some owners make serious mistakes when storing equipment. Because of this, his condition deteriorates faster and his performance decreases.
With regular maintenance, you can identify various malfunctions and shortcomings before they lead to complete breakdown of the tool. Timely and correct adjustment of the saw will help avoid injury during work.
