How to stick film on a tablet

A tablet as a product, according to government standards, must be supplied with a protective film glued to the screen. The role of this film is clear: it protects the monitor from debris, dust, grease and mechanical damage. But over time, with active use, this film becomes unusable: air bubbles are inevitably driven under it, causing a distortion in the perception of what is happening on the screen and preventing the passage of the signal. In addition, many developers place advertising on the film, which also interferes. In any case, sooner or later, the protective coating will have to be changed.

How to properly apply protective film

Of course, there are users who refuse protection and calmly move their fingers across the bare screen. But then the monitor will quickly use up its resource.

If a person has never glued a new film to the screen of his tablet before and decides to do it himself, he risks ruining the new coating and the screen itself.

Reference! Without the proper skills, it is almost impossible to stick the barrier fabric perfectly - pieces of debris, dirt, and air bubbles will definitely get inside. Repeated gluing and subsequent peeling of the film from the display will significantly reduce its service life.

First of all, you should pay attention to what you are buying. Cheap products will not force you to shell out a large amount of money on the counter, but they also serve much less often.Of course, you don’t need to go to extremes and buy something super advanced for a million per square decimeter - quality also has its limits. The best option would be to choose something average that doesn’t stand out in any way. It is advisable to choose a film whose manufacturer matches the manufacturer of the tablet. If there is no such thing, then a universal one, or “foreign” one, will also do.

It is strictly recommended to cut the purchased product to the shape of the tablet window. The procedure itself is best carried out in the bathroom (if hot water is available). The hot jet will attract dust particles, and this will protect the screen from unnecessary scratches. Make sure that splashes do not get on the gadget - all electronic devices are afraid of moisture.

If the tablet was used without film, then before applying it, you should wipe the display to rid it of greasy stains and microscopic debris. How and with what to wipe is written below in the corresponding section. The tablet must lie horizontally. Any hard, but not sharp, flat object in the shape of a thin rectangle will serve as a tool - a bank card is perfect.

The film comes with a second layer that protects the adhesive side from drying out. This second layer needs to be peeled off, and as soon as possible, so that nothing from the air has time to stick to it, but at the same time, very carefully glue the corners to the screen on the upper part. Now with one hand (if it is possible to do this together, then with both hands) you need to hold the lower, non-glued corners, and gradually apply the coating to the display, smoothing it with a flat object. Movements should be performed left and right, gradually moving towards the bottom.If you approach the process with enough patience and accuracy, the film will lay well.

How to wipe the screen

Water or damper napkins are not suitable for such procedures. Special compounds sold in equipment care stores can help you get rid of greasy stains. Often these forms take the form of a spray. The spray should be applied to a napkin, and it, in turn, should be used to wipe the screen. There is no need to press hard on it - the composition deals with harmful substances with simple contact.

Dust particles are removed using paper tape. It needs to be glued and then immediately torn off. The adhesive surface will take all the trash with it.

If the glass of the tablet is damaged so badly that cracks have formed on it, then there is no point in trying to glue the fragments together - the monitors of all modern devices, even those not equipped with sensors, contain liquid that spills out when broken. The display can be replaced at a service center.