How to change the microcircuit in a music center yourself

With the help of music centers, you can listen to your favorite compositions, organize concerts and celebrate holidays. To do this, you need to properly connect the equipment, make settings and start the selected audio recordings. To familiarize yourself with the capabilities of the equipment, you should read the instructions and operating instructions. There you can find answers to all questions.

However, sometimes problems may occur during operation that lead to sound distortion and deterioration in quality. In this case, it is necessary to repair or replace components. One of the most important design details is the microcircuit built into the product body. It is this that ensures the correct operation of the entire system. How to change the microcircuit yourself?

How to disassemble the music center?

If you need to repair or replace a microcircuit in your equipment, you should first properly disassemble the device in order to gain access to the necessary element. To do this, follow these steps:

1. Take a flathead screwdriver and some materials for convenience.
2. Unscrew the outer casing sheets on the sides and bottom. After this, remove the cover.
3. Now you will have access to the internal parts of the device. Using a screwdriver, unscrew all retaining bolts to gain access to the central part.
4. Find the microcircuit you are interested in from a wide variety of wires and sensors.
5. Carefully pry up its edges with tweezers or a knife. Be careful not to damage the body of the part. If it is broken, you can simply pull it out of the socket for further replacement.

Important! In some cases, parts may be securely soldered; strong mechanical force will be required to remove the elements.

How to replace a microcircuit: instructions

After gaining access to the main element, you can begin replacement. This is quite easy to do, following all the steps of the instructions:

1. Mark with a marker the mounting locations of all sensors and terminals.
2. Disconnect the old chip from the case using a soldering iron in hot air mode.
3. Insert a new element according to the notes.
4. Using a blowtorch, install everything in place.
5. Perform a test run of the system to assess the quality of operation.