How to connect speakers to a music center

Speakers are devices that serve as audio catalysts of sorts. They allow you to significantly increase the sound quality and volume, as well as apply effects on vibrations. The capabilities of these devices vary depending on their model and cost. To work, the speakers need to be connected to a music center. We'll tell you how to do this.

Connecting to a music center with clamps

This action is easy to carry out if you have a music center and speakers from one set.

Reference! Manufacturers of speaker systems ensure full compatibility of parts from the same set (with rare exceptions in the form of defects or low quality products).

However, not everyone is satisfied with the sound amplifiers that come with the main element of the speaker system.

But if additional components were purchased separately, this means that they cannot be combined. This is not difficult to do, just follow the instructions.

• Take the wires from the speakers and insert them into the corresponding holes of the music center, focusing on the color.
• Secure the clamps so that information is transmitted through the cable more accurately and the fastening is reliable.
• Insert the wire from the main acoustic department into the network and turn it on.
• Check the speakers' operation by playing several tracks.You can add effects to the sound using the main compartment settings.

Connecting to a music center without clamps

A similar connection is made if the cable from two speakers is connected into one plug. In this situation, it is necessary to check the possibility of connecting a unified 2.0 system to the music center.

Step-by-step verification and connection

• Get close to the music block and turn its back towards you (the one on which the input holes for audio device plugs are located).
• Find two inputs for connecting each speaker separately. Should be located next to them one more input, and a schematic representation that it replaces the previous two (for example, in the form of a table with an equal sign).

If there is such an entrance

1. Connect the plug from the speakers into it.
2. Insert the plug from the main compartment into the network.
3. Turn on the device.
4. Check the operation of the speakers by turning on a track and applying effects available on the music center to it.

If there is no such input

1. Go to the store and purchase an audio adapter. As a rule, it is a piece of plastic with one hole and two outlets. If you're lucky, you'll find an adapter with a cable - this will make the connection more flexible.
2. Insert the plug from the speakers into the adapter, and insert the protruding elements of the adapter into the left and right holes of the music center.
3. Insert the plug from the center into the socket.
4. Turn on the device and check the operation of the speakers.

Important! As a rule, audio adapters do not have “left” and “right” designations on the two outputs. Therefore, the user has a chance to make a mistake and insert it “upside down”.

The error can be identified by listening to audio recordings with two-channel sound.If a sound that should appear only on the right appears on the left, or vice versa, then you need to turn off the stereo and turn the adapter over.