Electric hood for the bathroom and toilet: which one is better to choose?

A hood for baths and toilets should have good performance (90-110 cubic meters per hour) and not consume much energy (about 14-18 W). Another important parameter is the noise level: the lower, the better. Not every device meets all of these requirements. The article discusses models that are optimally suited for almost any bath and are also affordable.

ERA FLOW 4 BB

This electric bathroom hood has an affordable price and fairly high quality. When choosing, you should pay attention to this model or others marked “BB”. They all have ball bearings. And although bushing devices are much cheaper, they are less reliable.

The motor of this fan has a power of 14 W, which makes it possible to process air with a volume of more than 100 m3 in 1 hour. The noise level is low - 35 dB. The device is equipped with a non-return valve. There is only one significant drawback - the body is plastic, it is inexpensive, but not so reliable.

Dospel Rico 100 S

Another inexpensive electric hood for the bathroom and toilet, developing a power of 15 W and a productivity of about 100 m3 per hour. The noise level is within 40 dB, which is quite normal.

It is worth considering that the device develops pressure up to 35 Pa, and this is not enough for old, heavily clogged ventilation.But if the channels are regularly cleaned by the management company or the home owners themselves, the device is quite suitable.

One of the disadvantages is the fact that this electric hood for the bathroom does not have a check valve. In addition, the plastic is quite thin, requiring care during installation.

Soler & Palau DECOR 100 CHZ

A fairly powerful electric hood for the toilet, pumping 95 cubic meters of air in 1 hour. The power indicator is 13 W, while the engine reaches more than 2000 revolutions per minute.

This ceiling hood for bathroom and toilet has several advantages;

• there is a forced-on input;
• high-quality assembly, reliability;
• the presence of a hygrostat and timer, which can be configured at your discretion.

However, it must be taken into account that the noise level reaches 40 dB. This figure is within acceptable limits, but the measurement was taken at a distance of 1.5 m. If the bath is too small, the sound may seem quite loud.

Electrolux EAFM-100TH

If we talk about which hood to install in the bathroom in terms of price and quality ratio, we can highlight this particular model. It consumes only 15 W and at the same time pumps almost 100 m3 of air volume in 1 hour.

Flows are taken from the sides, since the front side is “blind”. Externally, the device looks aesthetically pleasing, since there is no “hole” in the wall. Another plus is the presence of a timer that allows you to set operating and shutdown times.

There is also an input through which the device is turned on forcibly. The unit has a hygrostat that can be adjusted over a wide range. But the noise level is quite high.

Blauberg Aero 100SH

This toilet hood has an affordable price and good quality. Pumps more than 100 cubic meters of air in 1 hour, while consuming only 14 W. The noise is within acceptable limits - 38 dBa, that is, acoustic decibels. This is an indicator that demonstrates the strength of sound not in general, but specifically in the perception of the human ear.

The installation has a timer and a hygrostat. The chip that controls them is mounted in the central part at the bottom (under the panel that goes in front). Among the advantages are:

• reliable motor with ball bearings;
• noise is within normal limits;
• can be turned on forcibly;
• There is a hygrostat and a timer.

There is only one significant drawback - the board is not reliable enough. This must be taken into account when installing the device.

A mini-hood for a toilet should be productive and at the same time moderately noisy. Reliability is no less important - it is better to choose devices with ball bearings. As for price, it should not be among the first criteria. In fact, it is better to overpay a moderate amount than to buy unreliable devices from little-known manufacturers.