How to check shock absorbers on a car? Learning how to change shock absorbers on a washing machine

There are several ways to check the shock absorbers on a car. First of all, you need to listen to the operation of the device in normal mode, during rinsing, and also during spinning. If extraneous sounds appear, it is necessary to disassemble the unit and inspect the shock absorbers. This article explains how to do this.

Main symptoms and causes of malfunction

Before you understand how to remove shock absorbers from an Indesit washing machine or another model, you need to find out in what cases they break. In general, these are fairly reliable parts that rarely fail. But there are several signs that directly or indirectly indicate a breakdown:

• when rotating at high speeds, the drum taps on the inner surface of the glass;
• when the drum stops, you can hear an uncharacteristic knock;
• Replacing the shock absorbers of the washing machine is also required in cases where periodic tapping is heard during rinsing (at equal time intervals);
• the drum rotates with obvious effort, the movement is tight, and it is in close contact with the surface of the cuff;
• if the spin cycle is in progress, the unit vibrates strongly - in this case, repair of the shock absorbers of the washing machine is also necessary.

As a rule, elements break only over the years, and the reason is objective - natural wear and tear.If such phenomena are observed with a new device, this may be due to careless transportation or a manufacturing defect.

To carry out repairs, purchase new shock absorbers for the Indesit or other brands of washing machines. Although sometimes it happens that the parts themselves are intact, but the bolts securing them have worn out. In any case, you will first need to disassemble and carefully inspect each element, and then decide on replacement.

How to make a replacement

You can replace shock absorbers on an LG washing machine or other devices yourself. All you need is a few wrenches and a flat head screwdriver. The sequence of actions is as follows:

1. Unscrew each bolt and remove the panel from above.
2. Remove the tray for pouring the powder mixture and dismantle the panel from below. You need to act carefully so as not to damage the wiring.
3. The next step in the instructions on how to remove shock absorbers from a washing machine involves removing the cuff. To do this, first loosen the metal clamp and then remove the elastic band.
4. Unscrew each bolt and remove the panel from the front.
5. Disconnect the wires and remove the lock that locks the door.
6. At the bottom of the machine you can find shock absorbers. To remove them, just unscrew all the mounting bolts. On some models they are secured with special latches that need to be released.
7. At the last stage, the shock absorbers on the Indesit washing machine are actually replaced. It is necessary to supply new parts and secure them with bolts, and then install all the parts in the reverse order.

How to increase the life of shock absorbers

After installation, it is recommended to take care of such an important condition as lubricant for shock absorbers of washing machines.It reduces friction and thereby significantly increases the service life of parts. For lubrication, you should not use such common products as grease or WD-40.

Instead, special compounds are used:

• "PMS-250000";
• "PMS-600000"
• "Silicon-Fett";
• "MS SPORT".

Repairing shock absorbers is quite simple. In most cases, parts cannot be restored - over time they wear out so much that it is easier to replace each element. Moreover, you can do this yourself, but if you don’t have the skill, it’s easier to contact a service center.