How to replace the pump of an Indesit washing machine? Changing the washing machine drain pump yourself

Replacing the pump of an Indesit washing machine is necessary in cases where the water does not drain at all or drains for quite a long time, and the unit itself is too noisy. The replacement process is quite simple and does not require special equipment or skills. Step-by-step instructions with photos are presented in this article.

How to diagnose a breakdown

First you need to make sure that it is the pump in the Indesit washing machine that needs to be replaced. Usually the device performs diagnostics itself and displays error F05. If there is no display, then a combination of indicators will light up:

• super wash;
• extra rinse mode;
• soaking laundry;
• spin mode.

If these signals are not present, you can watch how the machine washes. There are several signs to make sure that the drain pump has failed:

• the water drains, but noticeably longer than usual;
• the unit finished washing, but the water remained in the tank;
• the machine drains the water, and the program is not yet finished;
• The water drains normally, but the installation makes a strong noise.

The reasons are often related to the pump, so you need to figure out how to remove the drain pump of the Indesit washing machine. Although such phenomena can also be observed in the case of a clogged siphon, sewer pipe and siphon.If in doubt, it is worth checking these elements as well.

Tools and materials

Replacing the drain pump in an Indesit washing machine begins with preparing the necessary tools and materials. To do this you need to take:

• screwdriver;
• a knife or other tool with a dull blade;
• penknife;
• pliers;
• multimeter

You will also need the drain pump itself. It is better to purchase a spare part last, after it is clear that it is the pump that has broken.

Step-by-step instruction

It is not difficult to understand how to change the pump in an Indesit washing machine. The step-by-step repair instructions are as follows:

1. Place the unit on its left side (as viewed from the front).
2. Finding the drain pump is not difficult - it is located in the corner, it looks like this.
3. Remove the front bottom panel - this can be done by hand without additional tools.
4. Unscrew the bolts that secure the pump from the outside.
5. The next step, how to replace the pump in an Indesit washing machine, involves turning the element clockwise and removing it.
6. At this stage it is better to take a photo so that later you can correctly install the new pump. Next, remove the red plug through which the wire is connected.
7. Unscrew the nut and remove the old pump. At this point, some water will flow out, so you need to prepare a cloth.
8. Install the new pump, aligning the bolt holes correctly.
9. Reassemble all parts in reverse order.
10. Install the front lower panel, return the machine to its previous position and test it in any wash mode.

Now it’s clear how to disassemble the pump of an Indesit washing machine. To do this, they first carry out diagnostics, then lay the unit on its left side and remove the old part.As you can see from the step-by-step instructions, removing the washing machine pump is a fairly simple procedure that can be completed in a few minutes. But if the error is related to another node, and there is no precise understanding of the cause, it is better to call a specialist.