What does it mean if the washing machine does not take water? Why does this happen and how to fix it?

If the washing machine does not draw water, in the simplest case the reason is due to a closed valve or a one-time electronics failure. Therefore, you first need to make sure there is water supply, and then reboot the device by unplugging it for a few minutes. But if this does not help, the reason is more serious - most likely, you will need to invite a specialist.

If the car is new

If the device is new and recently installed, the reasons may be very simple. First of all, you need to check the availability of water, since sometimes there are interruptions: for example, hot water flows, but cold water does not.

Next you need to do this:

1. Check whether the tap on the pipe is open or not.
2. Inspect the water supply hose - it should not be pinched or kinked.
3. Make sure the door is tightly closed. It needs to be opened and closed again when you hear a click.
4. Unplug the device from the outlet, wait 10 minutes and turn it on again. Sometimes washing machines malfunction, if the phenomenon is one-time, this is normal. But if it starts to recur, the electronic module may break down - repairs are required under warranty.

What you can check for yourself

In some cases, you can handle it yourself. After checking the door and rebooting the device, proceed as follows:

1. Make sure there is water and the tap is open.
2. It is also necessary to check whether water is supplied under normal pressure - this problem is especially relevant for the upper floors.
3. Check the valve mesh filter that supplies water. Sometimes it gets clogged, so it needs to be cleaned periodically.

In what cases is repair needed?

If the breakdown is more serious, repairs with a complete replacement of one or another part will definitely be required. The most common situations are:

1. Problems with the valve that supplies water. It consists of a coil and a membrane, and most often it is the coil that breaks. The main symptom will be a blocked hatch and lack of water intake.
2. Failure of the pressure switch, that is, the sensor that monitors the water level. When it “perceives” the tank to be full, no more water is collected. Therefore it is necessary to replace the part.
3. If the problems are related to the control module, the machine will also close the door and will not draw water. For an accurate determination, you need to carry out correct diagnostics and clean the oxidized contacts. The processor board may need to be completely replaced.
4. Another case is a wiring fault. This is observed during prolonged operation and strong vibrations, as a result of which the wires physically rub against each other. In such situations, complete replacement of damaged wires is also required.

Thus, when the machine does not take water, the reasons may be more or less serious. You can carry out independent repairs only after an accurate diagnosis and with the appropriate skills. If they are not there, you should contact a specialist so as not to damage the unit.