DIY steam cleaner

Often in everyday life situations arise when you need to remove stubborn stains, but ordinary chemical cleaning agents do not help. Throwing away furniture or renovating is not the answer. In this article, we will look at how in just 30 minutes you can make a simple steam cleaner with your own hands and use it to get rid of the problem that has arisen.

What you need to make a homemade steam cleaner

In order to create a steam cleaner with your own hands, you will need the following materials:

1. A small glass jar with a screw cap - suitable for juice, jam, sauce, etc.
2. 3 regular shaving blades.
3. Durable cotton threads.
4. Matches.
5. A small tube, like an IV.
6. A small piece of insulated wire.
7. Ordinary rubber bands, which are often used for money.

IMPORTANT! The creation of such primitive devices can pose a potential danger to human health, so you should be careful during the creation process. When carrying out such a procedure in practice, it is important to understand that excess pressure and steam can cause the device to explode or cause harm to health from electric shock.

DIY steam cleaner

To heat the liquid in a primitive device, a so-called electrode heater is needed.In its role, you can use previously used blades from a regular razor. Ordinary matches can be used as an insulating element. The structure is connected using durable cotton threads. Electric current is supplied by a stranded insulated copper wire.

The work uses three regular razor blades. This makes it possible to significantly increase the area of ​​the electrodes when powered from an electrical network with a voltage of 120 Volts. When using electricity with a voltage of 220 Volts, you can use only 2 blades.

Next stage. It is necessary to make three holes of suitable size in the metal lid of the container being used. For the tube used, more is needed, and for electrical wires, less. The size should be determined depending on what wires and tube will be used. Once secured, they should be carefully sealed using silicone sealant.

This design looks like this:

The result should be a reservoir like this:

ATTENTION! To prevent the explosion of the created tank from the high pressure of the generated steam, do not screw the lid tightly onto the entire thread. It should be pressed against the jar using rubber bands for money.

Such a device can be used in practice to eliminate any dried contaminants, which are quite difficult to get rid of with the help of our usual chemicals and cleaning agents. The high efficiency of the self-created device has been proven through practical use. And most importantly, you can make it with your own hands in the shortest possible time.Let's hope this technology helps!