We are learning how to disassemble the lid of a blender. TOP best tips for disassembling and repairing a Bosch blender

If the blender does not work, it is quite possible to repair it yourself. For example, the motor may break down, the winding or fuse may burn out. Therefore, it is necessary to understand how to disassemble the blender lid, as well as find and fix the problem. Instructions and useful tips can be found in this article.

How to remove the cover

Repairing a Bosch blender begins with removing the cover, since it is under it that all the main parts are located. The step-by-step instructions are as follows:

1. Remove the plastic plug.
2. Unscrew both bolts with a screwdriver.
3. Insert a knife or screwdriver and carefully push both parts of the housing apart.
4. Exactly the same on the other side. As a rule, plastic parts hold well, so you need to apply quite a lot of force.
5. Pry the power button and remove it to disassemble the blender.
6. Unscrew the bolts with a screwdriver.
7. Take both parts apart and it should look like this.

If the speed switch is broken

Removing the cover will be necessary in a number of cases, for example, if the speed controller is faulty. Then you must first understand how to disassemble the blender chopper, and then act like this:

1. Remove the board - as a rule, it is green.
2. Disconnect the wires from it.
3. Turn on the soldering iron and desolder the board.
4. Then “ring” and make sure that all contacts are intact.
5. If individual contacts are not working, you can repair them yourself or contact a service center.

If the engine doesn't work

Bosch blender repair will also be needed in cases where the engine breaks down. In this case, the tool simply will not work or rotate at a very low speed. To diagnose a problem, you need to not only inspect, but also listen to how the device functions. The instructions are:

1. If the blender hums quietly when you turn it on, but the blade does not rotate at all, you need to disassemble the tool as shown above.
2. Next, remove the bowl and take a pencil or other long object. Use it to press the lock key.
3. If the knife still does not rotate, the cause of the breakdown is most likely related to the engine. The winding may have burned out. The part needs to be completely changed or a new blender purchased.
4. If the engine is working properly, check the power cord - the contacts may have come loose. They disassemble the case and “ring” it with a multimeter.
5. It is also recommended to make sure that there is a fuse under the housing and that it has not blown. If there has recently been a power outage in the network, this is probably the reason.
6. Finally, if all the methods do not work, you can simply check the outlet - most likely it is faulty.
7. Next, all that remains is to figure out how to assemble a Bosch blender. Essentially, you need to do the same steps, but in reverse order.

Thus, at home it is not difficult to figure out how to repair an immersion blender. The only tools you will need are flat-head screwdrivers, a soldering iron, and a knife. The main difficulty may be associated with detaching the two halves of the housing from each other.To do this, you need to apply force, and also use a knife to insert it into the seam and swing the parts.