Do-it-yourself cable for cleaning pipes. What to make a plumbing cable from

The cable for cleaning pipes with your own hands is made of steel wire 3-4 mm thick. Its end is bent into the shape of a hook, a ring is made on the other side and the blockage begins to be removed. Step-by-step instructions for making and using this device are described below.

How to make a cable

There are several options for making a plumbing cable with your own hands. If the blockage is small, you can use a bicycle cable or tape cut from an ordinary plastic bottle. But if the plug is serious, it is better to use thick wire as a basis:

1. Find the end and measure 30-40 cm.
2. Make the hook so wide that it is smaller compared to the diameter of the pipe.
3. Check how freely the plumbing cable moves with your own hands.
4. If necessary, adjust the hook size and begin cleaning.

This device is suitable for cast iron pipes. But if the system is complex and makes a lot of bends, it is better to make a pipe cleaning spring from a twisted steel cable. The instructions are:

1. Take a metal cable and cut a cord 1-3 m long. The more complex the blockage, the longer the length should be, but in any case the limit is 3 m.
2. Fluff the work surface.
3. Twist a ring at the other end, with which you can control the movement.
4. Lubricate all surfaces of the device with anti-corrosion agent or machine oil.

It is worth understanding that a DIY sewer cleaning cable is only suitable for clearing blockages within an apartment. If a traffic jam has formed in a riser, for example, between risers, far from the apartment, it is necessary to use professional equipment.

How to clean a pipe with a cable

Using the device is quite simple. The most important requirement is that the nozzle on the plumbing cable with your own hands should not contain sharp corners, so as not to damage the inner surface of the pipes.

Step-by-step instructions for using this tool are as follows:

1. Insert the free end into the pipe.
2. Start turning the channel clockwise, while moving it deeper and deeper.
3. Feel for the plug, understand where the cable rests.
4. Eliminate it by pushing it as far as possible.
5. Pull out the cable to clean the drain yourself.
6. Pour a bucket of boiling water into the pipe.

Rope care

It is likely that the cable will be needed more than once. Therefore, it is important to learn not only how to make it, but also how to properly care for it. The basic rules are:

1. After each cleaning, thoroughly rinse the entire length of the device with hot water and wipe with a cloth.
2. Dry thoroughly - preferably on the balcony.
3. Apply a layer of oil and wrap in film.
4. Store in a room with low humidity.

Thus, you can make the cable yourself. To do this, you only need wire cutters and pliers. But in some cases the device will not help. If the blockage is serious and is located far from the apartment’s riser, you will need to purchase a professional tool.