Philips food processor: instructions for use and care tips

The Philips food processor allows you to obtain juices from fruits and vegetables, including hard ones, such as beets and carrots. Before use, the device must be prepared in compliance with safety regulations. Thanks to this, the Philips juicer, the instructions for which are presented below, will last much longer than the warranty period.

Preparing for work

Instructions for using a Philips food processor begin with a description of preparing the tool for use. You need to do this:

1. Wash and rinse all parts that are being removed.
2. Pull the cord out of the compartment at the back of the case.
3. Set up a container to receive juice.
4. Place the container into which the leftovers are collected after squeezing, tilting it slightly forward (put the top first, then the bottom).
5. Insert the filter into the container to obtain fruit juice. Cover it with a lid and put it in place.
6. Before using the filter, you need to check its integrity. If there are even small cracks, such a part cannot be used - fragments may get into the juice.
7. Place the latches on the cover and press until they click.
8. Place a container to collect juice under the spout of the device.

How to get juice

The next point in the instructions for using the Philips juicer is the process of extracting juice. The sequence of actions is as follows:

1. Take the fruits, rinse and peel, cut into pieces and place in a container.
2. Set low or standard speed mode.The first mode is suitable for preparing juice from soft types of raw materials, for example, tomato, grape, berry. The second is made from solid raw materials, for example, carrots.
3. Place the raw material in the loading hole, push it closer to the rotating element using a pusher. You need to press it gently, without pressing too hard.
4. After finishing work, turn off the device and wait until the rotation stops.
5. Place the foam separation element and close the container. Thanks to this, after spilling, the foam will remain in the bowl.

Tips for use

To get high-quality juice and extend the life of the device, it is recommended to follow these tips:

1. Use only fresh, not dried fruits and vegetables, as they contain the maximum amount of juice.
2. Do not peel or zest the raw materials. Only thick rinds of raw beets, oranges and pineapples should be removed. By preserving the peel, the drink will be rich in flavor and vitamins.
3. When preparing an apple, you need to consider the variety. The juicier the fruit, the more liquid the squeezed juice will be.
4. If fruits contain a lot of starch, for example, mangoes, bananas, avocados, it will not be possible to extract juice from them in a juicer. To do this, it is better to use a blender or different types of food processors.
5. In some cases, both fruits and greens can be used to obtain juice. These are, for example, celery and lettuce leaves.

Care Tips

Caring for the device is quite simple. The basic rule is to wash all parts immediately after use. To do this, use any liquid detergent diluted in warm water. All clogged elements are placed in a small basin for 15 minutes, then wiped using a sponge or brush. Rinse under the tap and allow to dry.

You can also use a weak solution of baking soda. The tool is disassembled and the parts are allowed to sit for 20-30 minutes. Thanks to this, the stuck parts of the cake are easier to separate. After this, they pass with a sponge or brush, then rinse with water and dry.

The Philips juicer, the instructions for which are described in this article, is a fairly simple device that is comfortable to work with. However, it is important to follow basic safety precautions - make sure that the wire is intact, the plug is not in the water, and also do not touch the cutting part with your hands, even if the device is turned off.