How to properly clean the evaporator. Can it be washed with water

As you use it, the liquid that is poured into the tank clogs the passages, which is why the electronic cigarette begins to work noticeably worse. Therefore, it is necessary to understand how to clean the evaporator, and whether it is possible to use water for this. Step-by-step instructions and descriptions of different methods can be found in this article.

Can it be washed with water?

One of the common questions is whether the evaporator can be flushed with water. This is a completely acceptable technique, but subject to several rules:

1. The vape is washed under the pressure of running water, but it should be of medium power. Otherwise, a strong flow may lead to deformation of the spiral.
2. You definitely shouldn’t use hot water, much less boiling water. This will not make the vape cleaner and may spoil it.
3. There is no doubt whether the evaporator can be washed with water. But it is important to let the device dry completely and only then assemble it.
4. Finally, you can rinse your e-cigarette using only water, no cleaning products. If you use soap or dishwashing preparations, you may notice their aftertaste during smoking later.

How to clean your vape

If we talk about how to clean a vape, the main way is to rinse it under the tap. But there are other methods, for example, burning or using an ultrasonic bath.

Washing under water

There is no need to worry about what will happen if the evaporator is washed with water. If you do this carefully, you should not expect any consequences. Just follow these step-by-step instructions:

1. Completely drain the liquid from the tank, being careful not to leave even drops. To do this, you can blow out the atomizer from the side where the contacts are located.
2. Rinse the tank under the tap (the water should be warm and not scald your hands). If there is any doubt whether it is possible to wash the vape tank with water, you can use other means, for example, alcohol (can be replaced with vodka), 9% vinegar or citric acid solution (a teaspoon in half a glass).
3. Place the tank on a clean, dry cloth.
4. Wait until it dries completely and thoroughly blow out the evaporator again.
5. Assemble the device and test its operation.

Ultrasonic bath

Users who doubt whether the evaporator can be washed with water are recommended to use another cleaning method - in an ultrasonic bath. This is a small container with a device that generates waves of the appropriate frequency. You can purchase the device at an affordable price.

Baths are used to clean various products, for example, chips, semiconductor circuit boards, and jewelry. Therefore, they are quite suitable for a tank, which just needs to be placed in a container for a few minutes and turn on the device.

Burning the atomizer

There is another way to clean an electronic cigarette. The instructions are:

1. Rinse the atomizer under warm running water of moderate pressure as described above.
2. Blow thoroughly from the contact side.
3. Press and hold the button for a few seconds without the cartridge.
4. Repeat this action 5-10 times.
5. Place the atomizer and wait until it cools down completely.
6. Insert an empty cartridge.
7. Take several slow, deep puffs until the steam disappears completely.

This cleaning method is a last resort, which should be used only in the presence of severe contamination. The danger is that burning through can damage the evaporator. Therefore, it is better to figure out how to rinse the vape evaporator using plain water, a solution of vinegar, citric acid and other household products.